Go Back   Cruiser Log World Cruising & Sailing Forums > Cruising Forums > The Bosun's Locker > Rigging & Sails
Cruiser Wiki Click Here to Login

Join Cruiser Log Today

Reply
 
Thread Tools Search this Thread Display Modes
 
Old 04-27-2010, 02:29 PM   #1
Rear Admiral
 
Aquaria's Avatar
 
Join Date: Mar 2007
Home Port: Hamburg
Vessel Name: Aquaria
Posts: 281
Default

My rigging wires are now 20 years old. Now I read in different magazines that the wires should be exchanged after 20 years of service, no matter what, even if the wires and its terminals still look fine. Â* Somewhere else I read something about 25.000 miles that recommend a change.Â*

Of corse, Rigging specialists urgently recommend a change (to make a living), neighbouring boat owners (older boats) not even thought about a change.Â*

In our case the outer strands of the fore stay wire show some slight signs of chafe at the top end (caused by the aluminum profile), I got the recommendation to replace the forestay. That makes sence. But as the wires in general loose lots of their flexibility over the years, it is strongly advised to replace all wires at is it not a good idea to mix old and new wires in the rigging.

How should I count these 20 years. The rigging 20 years in place? The wire 20 years old but half of the time stowed away in the shed?

Any other advice and recommendations?

Uwe

SY Aquaria

Â*
__________________

__________________
If you have the time, you alwas have the right winds.

More on my Centurion 32:
https://www.cabinetdeparodontologie.n...ria/index.html
I've Contributed to the Cruisers Wiki: Germany, Background, Cruising/Sailing the German Bight
Aquaria is offline   Reply With Quote
Old 04-27-2010, 03:12 PM   #2
Moderator
 
redbopeep's Avatar
 
Join Date: Jun 2007
Home Port: Washington DC
Vessel Name: SV Mahdee
Posts: 3,236
Default

While properly maintained galvanized wire can last far longer, if the wire is stainless steel 1x19, 20 yrs in service is too long imho, especially set into swages... Fatigue and crevice corrosion are often invisible until things break. If you run your hand along the wire and can find broken strands, know there are more inside where you cannot see. In service means installed on the boat. Rocking gently at the slip causes fatigue just as sailing does. I know sailors who choose to have a shroud or two destructively tested by a rigging shop to ascertain the condition of a rig. The freq. of such testing is 5 yrs service.

good luck.
__________________

__________________
"Do or do not. There is no try." - Yoda

What we're doing - The sailing life aboard and the Schooner Chandlery.

redbopeep is offline   Reply With Quote
Old 04-27-2010, 03:54 PM   #3
Rear Admiral
 
Aquaria's Avatar
 
Join Date: Mar 2007
Home Port: Hamburg
Vessel Name: Aquaria
Posts: 281
Default

Quote:
Originally Posted by redbopeep' date='27 April 2010 - 05:12 PM View Post

... If you run your hand along the wire and can find broken strands, know there are more inside where you cannot see...
... suppose, you mean halyard wires, where broken strands can cause bloody fingers... We don't have them on board.

Yes, in place is installed (normally from April to November).

But it is a good idea to have a shroud destructively tested!

Thanks!

Uwe

SY Aquaria

__________________
If you have the time, you alwas have the right winds.

More on my Centurion 32:
https://www.cabinetdeparodontologie.n...ria/index.html
I've Contributed to the Cruisers Wiki: Germany, Background, Cruising/Sailing the German Bight
Aquaria is offline   Reply With Quote
Old 04-27-2010, 07:32 PM   #4
Moderator
 
redbopeep's Avatar
 
Join Date: Jun 2007
Home Port: Washington DC
Vessel Name: SV Mahdee
Posts: 3,236
Default

I mean any stay or shroud can have broken wires along its length. Inspect all to see.

Your rig is so old that I wouldn't consider destructive testing. I would only dt on newer rig. jmho.
__________________
"Do or do not. There is no try." - Yoda

What we're doing - The sailing life aboard and the Schooner Chandlery.

redbopeep is offline   Reply With Quote
Old 05-27-2010, 07:01 PM   #5
Ensign
 
Join Date: May 2010
Posts: 4
Default

I would recommend a careful inspection of all the rigging when it is in your shed. Clean it all thoroughly and check for pitting, cracks, bends, hole elongation, or chafe. Dye penetrants can be used to check for small cracks. If any of these faults are present, I would replace. Often people neglect careful inspection of the other hardware when replacing rigging wire. Remove and inspect the mast tangs, bolts, compression tubes, etc. Take the spreaders off and inspect the supporting hardware. Rigging wire can last a long time if properly set up, tensioned, and cared for. A local rigger told me most rigs are lost from other causes than wire or swages.

Fair Winds!
__________________
SVLOKI is offline   Reply With Quote
Reply

Tags
rigging


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing A Cutlass Bearing Lighthouse Repairs & Maintenance 2 07-10-2019 09:02 PM
Replacing Raw-water Pump Impeller Lighthouse Repairs & Maintenance 5 08-08-2016 09:01 PM
Replacing Seals On Wagner Hydraulic Ram GRANDSAILOR Repairs & Maintenance 1 03-02-2010 12:53 AM
Replacing Running Rigging - Need Help Waterdog Rigging & Sails 6 11-01-2009 02:11 PM
Tuning your own Rigging? Bajamas Rigging & Sails 12 07-14-2006 09:44 PM

Our Communities

Our communities encompass many different hobbies and interests, but each one is built on friendly, intelligent membership.

» More about our Communities

Automotive Communities

Our Automotive communities encompass many different makes and models. From U.S. domestics to European Saloons.

» More about our Automotive Communities

RV & Travel Trailer Communities

Our RV & Travel Trailer sites encompasses virtually all types of Recreational Vehicles, from brand-specific to general RV communities.

» More about our RV Communities

Marine Communities

Our Marine websites focus on Cruising and Sailing Vessels, including forums and the largest cruising Wiki project on the web today.

» More about our Marine Communities


All times are GMT. The time now is 11:27 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.0
×